2. Installing glides
1. Carefully lift one side of the desk and place a short wooden 4x4 or 2x4 block
(or equivalent support) under the leg. This may require two people.
Figure 2
.
2. Thread the two glides into the leg, tighten securely, and remove block.
3. Repeat this procedure on the other side of the desk.
4. The glides can be adjusted with the included glide wrench to level the desk if
necessary.
leg
glide
wooden
block
1. Unlock monitor column
0110657R5 Page 3 of 11
Assembly / Setup
Note: Every Flex Insight desk ships with one or two carriage bolts with wing
nuts locked in a keyhole slot under the bottom of the keyboard tray. These
fasteners prevent monitor column movement during shipping, and will need
to be removed to get the monitor column to function. A picture of the bolt
and wing nut is shown here from the back side of the desk. To remove,
unscrew the wing nut by hand, and slip the bolt out of the keyhole slot. The
fasteners should be retained for reuse if you will be transporting the desk in
the future.
If you transport the desk (in a trailer or truck) it is recommended to replace
the carriage bolt and wing nut. To replace, start the wing nut on the end
of the bolt and push the monitor column down into the lowered position.
Wiggle the head of the bolt into the slot from the large side of the keyhole.
Let the monitor column rise slightly to put tension on the wing nut. Tighten
down until monitor column does not move and is secure.
Carriage Bolt
Keyhole Slot
Wing Nut
Monitor Column
Figure 2
glide wrench
(included)
Tools
Required
Figure 1
