0118738R9 Page 9 of 17
Overbridge
panel
Note: Blank overbridge panels require the cus
-
tomer to make necessary cutouts with a jigsaw
or router. This has a moderate difficulty rating,
so experience and skill with tools is required.
1/4-20 x 35mm
JC bolt
(2 required)
Overbridge frame
2” grommet
Note: The overbridge panel is symmetrical. Rotating or flipping the panel
180° and re-attaching to the overbridge will allow you to place the cutout
on the opposite side of the overbridge if necessary.
Figure 7A
1. Before you begin, refer to the panel dimensions in
Figure 7B
for
maximum recommended cutout sizes.
2.
Identify the size and position (left, centered, or right) of each cutout
needed.
3. Identify the depth of your device to verify it will not interfere with the
worksurface or any other objects under the overbridge when the
panel is attached.
Figure 7C
.
4. When the cutout location(s) have been determined, locate and mark the
exact cutout area(s) on the panel with a pencil.
Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
5.
Carefully make the cutout(s) in the panel using a jigsaw or router.
6. Set the panel into the overbridge frame opening. Note: It may be
necessary in some cases to install the electronic device into the
panel before attaching the panel to the overbridge.
7.
Secure with (2) 1/4-20 x 35mm JC bolts and tighten securely.
8.
Install (2) 2” grommets.
Tools Required
Jigsaw or router
Drill
Pencil
Masking
tape
Drill bit
Measuring
Device
4
mm
Optional Overbridge Insert Panel Cutouts
