Figure 1A
Figure 1B
1. Install 3-piece skirt
4
mm
0118738R9 Page 3 of 17
Assembly / Setup
Side skirt
Side skirt
8-32 x 1/2” PH
Thread-cutting screws
(4 required)
Audience-side skirt
Skirt Assembly
Instructor-side
Keyhole
slot
1/4-20 x 40mm JC bolt
(install from inside lectern)
Assembled skirt
1/4-20 x 40mm JC bolt
(install from inside lectern)
3.
Hook the skirt keyhole slot at the end of each side skirt over the pre-
installed #14 x 7/8” PHSM screw.
Figure 1C.
4.
From inside the lectern (on audience-side) , install (2) 1/4-20 x 40mm
JC bolts through the base panel to secure the assembled skirt, and
tighten securely.
Figure 1C
Note: The skirt is designed to be easily re
-
movable. It should be removed if the lectern
will be moved over long distances or thresh
-
olds to prevent damage to the skirt panels.
Do not tip lectern to remove or install!
#14 x 7/8” PHSM
(pre-installed)
1.
Attach the two side skirts to the audience-side skirt with (4)
8-32 x 1/2” PH Thread-cutting screws.
Figure 1A
.
2. Move lectern into position over the assembled skirt as
shown.
Figure 1B.
