4mm hex
wrench
(included)
Tools
Required
Directional wheel operation
Figure 10
Note:
Wheel rotation cannot be locked on directional
wheels. To prevent the cart from rolling, lock the stan-
dard locking balloon wheels on the other side of the cart.
brake lever
Two directional, swivel locking 5” directional balloon wheels are provided and can be rotated
and locked at 180° intervals to be rigid, or unlocked to be swivel. This provides control when
transporting between classrooms, while allowing maneuverability in tight spaces.
1. To lock the wheel direction, align each wheel with the cart width and depress
the brake lever.
Figure 10
.
(Each wheel can be locked at 180° intervals)
2. To resume swivel operation, unlock each brake lever.
0116141 Page 9 of 11
Figure 9
Door stop adjustment
If necessary, the offset door stop can be rotated slightly to adjust
the closed position of the doors and lock rods.
1. To rotate, loosen the JC bolt slightly with a 4mm hex wrench.
Figure 9
.
2. Rotate the door stop until the door is positioned correctly.
3. Re-tighten the JC bolt securely.
Moving and parking the cart
• Before moving, unplug and secure all power cords.
• Close and lock doors.
• Remove any items from the top of the worksurface.
• Unlock the casters.
• Push slowly and carefully. Do not move over uneven or irregular surfaces.
• Do not allow children to move.
• Lock the casters after moving.
•
Do not park unit in areas of heavy traffic.
• Do not run power cords across hallways, classrooms, or other areas where they will be walked on.
• Do not leave unit unattended in areas where children have access.
• Keep doors closed and locked whenever unit is unattended or parked.
• Keep casters locked whenever the cart is unattended.
