Spectrum Industries 55377 Owner'S Manual Download Page 2

Hardware Package Contents

0116141 Page 2 of 11

(4) 052605

1/4-20 x 15mm JC bolts

(2) 0105648

cord wrap bracket

(1) 025039

4mm hex wrench

•  Read this owner’s manual before assembly or operation.

•  Do not allow children to move the cart.

•  Proceed slowly and carefully when moving the cart.

•  For indoor use only.  Do not install or store the cart where it will be exposed to 

moisture.

•  Do not block the ventilation openings.

•  Avoid uneven loading of the equipment into the cart.  Uneven weight distribution 

could cause the cart to tip when the cart is moving.

•  Do not allow anyone to sit, stand, or climb on the cart.

•  Use a damp, soft-cloth, or sponge, with mild soap or detergent solution to clean 

dirty surfaces.  Do not use harsh solvents or abrasives.

•  This cart is intended for institutional use.  It does not have any user-serviceable 

parts or user-maintenance requirements.  If servicing is necessary, please 

contact Spectrum Industries for assistance.

Electrical Safety:

•  Keep the power switch in the OFF position before plugging or unplugging 

from the wall outlet.

•  Turn OFF the devices before plugging them into the cart.

•  Ensure total device / equipment load does not exceed 12-amps.

•  Do not plug the power cord into an extension cord.

•  Inspect the power cords for damage before each use.  Do not use power 

cords that are damaged.

•  Unplug power cord from electrical outlet by gripping the cord.  Do not unplug 

the power cord by pulling only on the cord.

•  Do not step on, drive over, drag, or place objects on the power cord.

•  For added safety, plug the cart into a grounded outlet controlled by a GFI 

(Ground Fault Interrupter) circuit breaker.

• 

Damaged electrical components can create signifi cant hazards to users and 

is not covered by the warranty.  Repairs should always be performed by a 

qualifi ed electrician.

• 

Electrical devices are not toys.  Children are often unaware of the hazards 

associated with electrical devices.  This cart must always be used by adults 

or with adult supervision.

Warning

 - Relocating audio and/or video equipment to furniture not specifi cally 

designed to support audio and/or video equipment may result in death or 

serious injury due to the furnishing collapsing or over turning onto a child.

Warning

 - Death or serious injury may occur when children climb on audio 

and/or video equipment furniture.  A remote control or toys placed on the 

furnishing may encourage a child to climb on the furnishing and as a result the 

furnishing may tip over on to the child.

Important Safety and Care Instructions

Not Included

•  Imaging Ethernet switch

•  Wireless access point

•  Laptops and charging transformers

•  RJ45 cords

(4) 026064

1/4-20 x 5/8” PHMS

(100) 058423

5-1/2” zip tie

Summary of Contents for 55377












Reviews: