Note:
If a wireless access point is needed, it can
be mounted on the left or right side panel or located
inside the cord management tray.
6. Place the laptop chargers into the two cord management trays and plug into power units.
Figure 7
.
(Excess cord can be
bundled and secured inside the tray.) Chargers can be secured to the tray using the slots if necessary.
7. Route each charge cord through the divider panel cutout or over the divider panel, up to and across the wire tray, and down
to each laptop bay. Using the wire retention device is not necessary with the charge cords if frequent removal is required.
8. Make sure each RJ45 Ethernet cable and charge cord is routed down in front of each laptop.
9. Place up to 30 laptops in the cart with the charge ports facing as close to the student-side of the cart as possible.
instructor-side view
Figure 7
cycle timer
plugs from upper and
lower power units
plug from 7-outlet
power strip
7-outlet power strip
(supplies power to wireless
access point, Ethernet switch,
and ventilation fans)
Ethernet switch
(not included)
RJ45 Ethernet
cords
(not included)
upper power unit
lower power unit
cord management tray
(stores laptop chargers)
divider panel cutout
(routes charger cords and
Ethernet cords to each laptop)
0116141 Page 7 of 11
