cantilever
worksurface
bracket
(4 required)
0115700R2 Page 6 of 17
4. Install optional end worksurfaces
1. Carefully flip the table upright-this will take 2-3 people.
2. Tip the 4 cantilever end worksurface brackets while inserting
into the leg slots.
Figure 4A
.
3. Push down firmly on the end of each arm to “set” the arm
into position. All 4 arms should be level with the floor.
The end worksurface cantilever brack
-
ets have to be installed into the slots
before any worksurfaces are installed.
Figure 4A
Figure 4B
4. Set the end worksurface onto the brackets and align the mounting holes.
Figure 4B
.
5. Install two 1/4-20 x 5/8” PHM screws through each bracket to secure the end worksurface. Do not tighten completely.
6. Install one 1/4-20 x 5/8” PHM screw per bracket through the bracket and into the table leg. Do not tighten completely.
7. Install the two unit-to-unit brackets with (2) 1/4-20 x 5/8” PHM screws. Do not tighten completely.
Keep all installed fasteners
from step 4 loose until step 6.
end worksurface
(curved shown)
unit-to-unit bracket with
(2) 1/4-20 x 5/8” PHMS
1/4-20 x 5/8”
PHMS
1/4-20 x 5/8”
PHMS
unit-to-unit bracket with
(2) 1/4-20 x 5/8” PHMS
Phillips
screwdriver
Tools Required
Cordless drill
with long magnetic
Phillips driver
or
(best)
