Spectrum Controls Micro800 2080sc-IF4U, Install Manual

Page: 11 / 20

Micro800™ 4 Ch Universal Analog Input Module
11
Publication 0100189-04 Rev. C
Adding the IF4U to CCW
The 2080sc-IF4U is configured for CCW (Connected Components
Workbench) using the PLUGIN_READ and PLUGIN_WRITE instructions
for generic plug-in modules.
The configuration, input data, and status structures discussed in the
sections above, are stored at different memory locations in the module.
The following table lists the memory location offset for each parameter
which is used when configuring the PLUGIN_READ, WRITE, and INFO
instructions.
Table 7 (Parameter Offset)
Parameter
Offset
(Dec) Comments
MOD_ID_LO 0 Module ID
MOD_ID_HI 1
VENDOR_ID_LO 2 Vendor ID
VENDOR_ID_HI 3
PRODUCT_TYPE_LO 4
PRODUCT_TYPE_HI 5
PRODUCT_CODE_LO 6
PRODUCT_CODE_HI 7
MOD_REV_LO 8 Minor revision, 1-255
MOD_REV_HI 9 Major revision, 1-127
MOD_STATUS
16
Module status register
(see Table 6)
SYNC_DATA_LATCH 26 Writing 0xA5 to this register triggers input data latch
CONFIG_IN0_LO 32 Channel Configuration
Registers
CONFIG_IN0_HI 33
CONFIG_IN1_LO 34
CONFIG_IN1_HI 35
CONFIG_IN2_LO 36
CONFIG_IN2_HI 37
CONFIG_IN3_LO 38
CONFIG_IN3_HI 39
INPUT_DATA_0_LO 48 Input Data
(Format is 16-bit signed integer)
INPUT_DATA_0_HI 49
INPUT_DATA_1_LO 50
INPUT_DATA_1_HI 51
INPUT_DATA_2_LO 52
INPUT_DATA_2_HI 53
INPUT_DATA_3_LO 54
INPUT_DATA_3_HI 55
CJC_DATA_LO 56
CJC_DATA_HI 57
OC_STATUS 80 Open-circuit status
U_O_RANGE_STATUS 81 Under/over range status