ENGLISH
ENGLISH
4
6
5
3
Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING:
Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING:
This product has been designed for use with the Pfister
15-3WD
(
Not included, order separately
) series diverter valve. It will not work with any other
product. Please review the
15-3WD
series diverter valve installation instructions before
installing this product.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing unit, remove the old unit
and clean the mounting surface thoroughly.
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Philips head screwdriver
• Adjustable wrench
• Flashlight
• Cloth
Your installation will require a pipe nipple for the spout installation as well as other
additional tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A
Hand Shower
B
Hose
C
Wall Mount
D
Drop Elbow
E
Screws (x2)
F
A
nchors (x2)
I
f any of these items are missing, please contact Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
5 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (
5A
) from Wall Mount (
5B
). Use Wall Mount Screw Holes (
5C
) to
place the desired location. Using a punch or awl, tap the screw hole locations.
Holes
must be vertically aligned.
6 ANCHOR INSTALLATION
Drill two
1
/
4
” Dia. Holes (
6A
). If installing into a stud, drill two
1
/
8
” Dia. holes and do not
use Anchors (
6B
). Insert Anchors (
6B
) into Holes (
6A
) and tap flush with wall.
7 WALL MOUNT INSTALLATION
Place Wall Mount (
7A
) onto wall and insert Mounting Screws (
7B
) through Wall Mount
Holes (
7C
) and tighten until Wall Mount (
7A
) is flush with the wall.
Do Not Over Tighten!
Insert Front Cover (
7D
) into Wall Mount (
7A
).
2
A
F
E
C
D
B
5A
5B
5B
5C
6A
6B
3/4”
7A
7D
7B
7C
7C
7B
7
