Page 3-4
Airnet II Particle Sensor Operations Manual
Chapter 3
Configuring for Ethernet
Configuration Commands
?
Displays a command summary for the selected operational mode (a summary of the
information in this table).
Sta(tus)
Displays the following information:
•
Current firmware version number
•
MAC address
•
IP address
•
Multicast address
•
Net mask
•
Gateway
•
Queue size (if used with Facility Net)
•
Connection status (if used with Facility Net)
•
Operational mode
Set ip aaa.bbb.ccc.ddd
The IP address is used when communicating across networks. This command sets the
address in the form of aaa.bbb.ccc.ddd. Each three-digit series is a value of 0–255,
separated by a period (
.
) character. An example of a valid IP address is
010.255.000.060
.
Set mas(k) aaa.bbb.ccc.ddd
Sets the network mask address using a decimal notation form of aaa.bbb.ccc.ddd.
Each three-digit series is a value of 0-255 separated by a period (.) character. The mask
separates the network address from the host address. This address is common to all
devices on the logical network. Usually the mask will be similar to 255.255.255.000.
Your network administrator will tell you if you need to enter this field.
Set mul(ticast) aaa.bbb.ccc.ddd
The multicast address must be set when using Facility Net. This command sets the
multicast address in a decimal notation form of aaa.bbb.ccc.ddd. Each three-digit
series is a value of 0-255 separated by a period (.) character. This address is unique to
the hardware it serves. An example of a valid multicast address is:
224.100.100.001
.
Set gat(eway) aaa.bbb.ccc.ddd
The gateway address is used when communicating across different networks. This
command sets the gateway address in a form of aaa.bbb.ccc.ddd. Each three-digit
series is a value of 0-255 separated by a period (.) character. Use gateway
000.000.000.000 if no gateway device is available on the network. An example of a valid
gateway address is:
010.255.000.060
.
