SpectraPure®Inc
.
Fax 480.894.6109 Fax us toll-free 1.877.527.7873
E-mail: [email protected] Visit us on the web www.spectrapure.com
7
SpectraPure
®
- INSTALLATION PROCEDURE FOR OPTIONAL FLOATS -
NOTE: Floats are to be
mounted horizontal when
dry and float up when
wet. In most instances we
recommend locating the
low float approx. half way
down your reservoir. DO
NOT OVERTIGHTEN when
installing the floats.
Float Installation:
1. Instal both the High and Low Floats onto a open container like a
Rubber
Maid
TM
trash can. The floats can be mounted by drilling a
5/8” hole. (The High Float shuts down the system, while the Low
Float turns the system on).
2. Connect the floats to the grey electrical extension cable and then to
the 3-socket connector on the S.V.C.
Solenoid Installation:
3. Un-screw current push-fitting from the carbon tank. (This fitting is
the input connection for the tap water).
4. Thread on the Brass Nipple to the Carbon Tank and then the
Solenoid. (Arrow on Solenoid points in the direction where the water
flows). PAGE 8.
5. Connect electrical cable to S.V.C. and thread last two fittings onto the
solenoid as shown on page 8.
SVC
SOLENOID
FLOATS
TRANSFORMER
6.
3/8” BULK HEAD FITTING: Use
a paddle bit and carefully drill a.
13/16” hole for installation at the top of the reservoir (above the high
level float)
7. Provide over-flow plumbing suitable for your storage tank and installation.
