SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
11
CARBON FIL
TER
CARBON FIL
TER
SEDIMENT FIL
TER
2
0
4
6
8
10
11
B A R
psi
1 0 0 x k P a
80
100
120
140
160
60
40
20
0
RO MEMBRANE
PERMEA
TE PUMP
ASO VALVE
FEED WATER
ADAPTER
TAP WATER
IN
BLADDER TANK
NOTE: ALL TUBING IS 1/4” UNLESS LABELED OTHERWISE
DRAIN SADDLE
3/8” BLUE
TUBING
3/8” BLUE TUBING
3/8” BLUE
TUBING
3/8” BLUE TUBING
3/8” BLACK
TUBING
“IN” PORT
“OUT” PORT
PERMEATE IN
BRINE IN
FAUCET
ADAPTER
3/8” BLUE TUBING
REDUCING TEE
PERMEATE PUMP
BRINE OUT
FLOW RESTRICTOR IN THIS
END OF RED TUBING
PERMEATE OUT
AIR GAP FAUCET
DRINKING WATER SYSTEM WITH PERMEATE PUMP (DWS-PP-90)
WORKING WITH PUSH FITTINGS
To remove the tubing from its push fitting:
1. Firmly depress and hold the push fitting collar down with your thumbnail.
2. While the push fitting collar is depressed, pull the tubing straight
out of the push fitting. Once the tubing is removed, release the
collar.
To reinsert the tubing into its push fitting:
1. Moisten the O-ring seal inside the push fitting by dripping a few
drops of clean water into the fitting.
2. Grasp the tubing near the end, and insert the tubing into the push
fitting.
3. Push the tubing into the fitting until resistance is felt, approximately
1/2 inch (12.7 mm). The tubing is now resting on the O-ring seal
inside the fitting.
4. Firmly push the tubing approximately an additional 1/4 inch (6.35 mm) further into the fitting to completely seat the
line into the fitting and past the O -ring seal.
5. Turn on the system water supply and check for leaks prior to further use or testing. If a leak is observed, you may not
have pushed the tubing into the push fitting far enough to seal the tubing against the O-ring. Turn off the system
water supply and reseat the tubing as described above.
COLLAR
O-RING
TO RELEASE, PUSH IN
COLLAR THEN PULL OUT
TUBE