15
2.
Click “
Enable
”
and set the alarm holding time.
3. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as motion detection. Please refer to motion
detection chapter for details.
z
SD Card Error
When there are some errors in writing to SD card, the corresponding alarms will be triggered.
1. Go to Event Setup
Æ
Anomaly
Æ
SD Card Error as shown below.
2. Click
“Enable” and set the alarm holding time.
3. Set alarm trigger options. Trigger Email and FTP. The setup steps are the same as motion detection. Please refer to
chapter for details.
4.3.3
Alarm Server
Go to Alarm
Æ
Alarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the camera will transfer the alarm
event to the alarm server. If an alarm server is not needed, there is no need to configure this section.
4.4
Analytics Configuration
This series of IP cameras supports certain smart functions, such as line crossing detection, region intrusion detection, etc.
These events can be triggered as alarm events.
For more accuracy, here are some recommendations for installation.
z
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.
z
Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).
z
Avoid places that are narrow or have too much shadowing.
z
Avoid scenario where the object
’s
color is similar to the background color.
z
At any time of day or night, please make sure the image of the camera is clear and with adequate and even light,
avoiding overexposure or too much darkness on both sides.
