Speck pumpen Zismatic 40/08 WE, Translation Of Original Operation Manual

Page: 42 / 52

Commissioning
16 EN 12|2019
5 Commissioning
 Before commissioning, check that the power network‘s
voltage and frequency values correspond to those indicated
on the pump’s name plate.
 Ensure that the pump is completely submerged.
1. Open the taps completely.
2. Establish
power supply.
 It can take a short time for the water to reach the end of
the piping!
 If the integrated sensor detects an absence of water, the
pump stops running. The sensor will make 4 attempts to start
the pump. If the pressure cannot be reset due to a lack of
water, the pump will keep the error message until the pump
is manually reactivated (by turning the power supply off and
on again).
Fig. .
 The pump is equipped with an anti-blocking system.
Following 100 seconds of inactivity the pump will
automatically be turned on for 2 seconds. This prevents the
hydraulic parts from becoming blocked.