User Manual
44
Slide the Selector™ baseplate along the side edges of the sample compartment with the
sample holder post (
3
) to the front of the compartment.
The baseplate locates into the spectrometer by engagement of the 15pin connector at
the back of the plate into the spectrometer and by guidance clips on the underside of the
plate.
The lilac colored pivoting handle on the underside of the plate is pulled towards you
when you need to remove the plate from the spectrometer.
Fit the L to R Selector™ optical unit (
1
) in accordance with the instructions on page 14.
P/N 549-112 - Shimadzu 8000, 8100, 8200, 8300, 8400, 8500, Prestige 21, IR Affinity,
Beam direction: Right to Left
Remove any 3” x 2” mount plate used in the spectrometer.
Place the Selector™ baseplate into the sample compartment with the sample holder
post (
3
) to the front of the compartment. (The Selector™ baseplate has a location strip
bar that engages into a slot in the spectrometer sample compartment floor.)
Hold the baseplate in position using the two cap head M5 screws supplied.
Fit the R to L Selector™ optical unit (
1
) in accordance with the instructions on page 14.
Any Other Spectrometers
For advice concerning spectrometers not included in this manual
please consult your nearest Specac representative.
3
