Spearhead TWIGA
21
Running Up Your Machine
1. First ensure the
rotor is in the ‘off’ position and PTO drive is disengaged, then
start the tractor.
2. Engage PTO into gear and run machine up to low revs, allowing oil to
circulate for about 15 minutes before operating arms.
3. Re-check oil level, - check for oil leaks. All Spearhead machines have been
run-up and checked thoroughly. However, hose connections can become
loose in transit and these should be checked again before the machine is put
to work.
4. Operate the arms through the full amount of travel; check all movements are
functioning correctly.
5. Place flail head near ground in a safe position and with tractor revs low, select
‘start’ position for the flail motor.
6. Once the rotor is settled, slowly increase revs of PTO to 540 R.P.M. and run
for a further 5 minutes. Slowly reduce revs and then disengage PTO.
7. Check all hoses for kinks, pinching, chafing and leaks.
8.
Re-check oil level.
Warning
The rotor will take a long time to stop. Never leave the cab until PTO
is disengaged, engine stopped and rotor has stopped spinning.
Summary of Contents for Twiga 555
Page 28: ...Spearhead TWIGA 27...
Page 63: ...Spearhead TWIGA 62...
