Spearhead Outfront Flail 130, Handbook & Parts Manual

Page: 14 / 49

Spearhead Outfront Flail
14
Machine preparation
Tractor requirements
Before fitting the machine to the tractor ensure that specification of the tractor meets the requirements
listed below.
A six spline PTO output with of one and three eighths inch diameter shaft; OR a 15 spline PTO output
with a one inch diameter shaft is available at the front of the tractor.
A PTO output speed of 2250 rev/min (max) / 2000 rev/min nominal is available at the front of the
tractor.
Hydraulic lift arms at the front of the tractor are available.
To ensure fore / aft stability ballast should be added to the tractor rear weight tray. The amount will
vary depending on type of tractor used and prevailing conditions.
Once the machine is mounted to the tractor and the tractor is correctly ballasted ensure that the
maximum axle loads for the tractor have not been exceeded. Failure to meet this requirement may
render the operator liable for infringement of public highway regulations.
Ensure that the tyres fitted to the tractor are correctly rated.