GB
15
Helpline No: UK 0151 649 1500 / IRE 189 094 6244
1. Remove cutter knife (E) from debris shield (F)
(Fig. R).
2. Place knife in a bench vise. Sharpen knife using a
flat file, being careful to maintain the angle of
cutting edge. File in one direction only.
앬
STORING A UNIT
Warning
: Failure to follow these steps may
cause varnish to form in the carburetor and difficult
starting or permanent damage following storage.
1.
Perform all the general maintenance
recommended in the Maintenance Section of
your User Manual.
2.
Clean exterior of engine, drive shaft assembly,
debris shield and stringhead.
3.
Drain fuel from the fuel tank.
4.
After fuel is drained, start engine.
5.
Run engine at idle until unit stops. This will purge
the carburetor of fuel.
6.
Allow engine to cool (approx. 5 minutes).
7.
Using a spark plug wrench, remove the spark
plug.
8.
Pour 1 teaspoon of clean 2-cycle oil into the
combustion chamber. Pull starter rope slowly
several times to coat internal components.
Replace spark plug.
9.
Store unit in a cool, dry place away from any
source of ignition such as an oil burner, water
heater, etc.
10. Do not transport and store the trimmer with the
blade fitted unless the supplied transport guard is
also fitted.
앬
REMOVING A UNIT FROM STORAGE
1.
Remove spark plug.
2.
Pull starter rope briskly to clear excess oil from
combustion chamber.
3.
Clean and gap spark plug or install a new spark
plug with proper gap.
4.
Prepare unit for operation.
5.
Fill fuel tank with proper fuel / oil mixture. See
Fuel and Lubrication Section.
앬
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Helpline Numbers:
UK:
0151 649 1500
IRE:
189 094 6244
Anleitung SPJBC 28 11.10.2006 17:47 Uhr Seite 15
