AFTER SALES HELPLINE
03456 052 068
22
WARNING!
Always switch the product off, disconnect it from the
power supply and let the product cool down before
performing inspection, maintenance and cleaning
work!
MAINTENANCE
i. Keep the underbody and cutting blade clean and free of
debris. Remove clippings from the discharge chute.
ii. Check all nuts and bolts periodically for tightness before
operation. After prolonged use, especially in sandy soil
conditions, the cutting blade will become worn and lose
some of its original shape. The cutting efficiency will be
reduced and the cutting blade should be replaced.
iii. Lubricate the cutting blade after each use to prolong the life
span of the cutting blade and product. Apply light machine
oil along the edge of the cutting blade.
Replacing the cutting blade
Keep the cutting blade sharp to ensure a good cutting
performance. Replace a worn or damaged cutting blade
with a new one of the same type or have it sharpened by a
qualified specialist.
i. Loosen the bolt anticlockwise using a suitable wrench and
remove it together with the blade.
ii. Replace the blade with a new one of the same type.
iii. Reattach the blade onto the spindle, pay attention to
correct alignment. Tighten the bolt clockwise with 16 Nm
min, 20 Nm max. to ensure safe operation of your product.
temperature is between 10 and 30°C.
NOTE:
Replace this cutting device after 50 hours mowing
or 2 years whichever is sooner regardless of condition.