20
AFTER SALES SUPPORT
0345 605 2067
OPERATE
5. While holding the saw unit securely on the ground (one foot
fix the rear handle, left hand hold the front handle), pull the
start handle four times to warm the engine. At this step, the
engine will usually not start.
6. Push the choke control (A) in to disengage. (Failure to do
this may cause the engine to flood).
7. Pull the start handle with smooth to start the engine, usually
it wil start in 5 times.
If the engine does not start, remove the spark plug, dry it
with paper towel and replace. Repeat the start procedure.
More information, check page 28.
8. After engine starts, allow the saw to run and warm up in
this position for 30 seconds.
9. Disengage the chain-brake, by pulling it back.
10 Push the safety trigger lock (C) firstly and engage the
throttle trigger (D).
B
A
1
2
3
5
4X
6
7
start
30s
8
9
C
D
a
