4.
Use the Remote rotational wheel and the tilt angles to cor-
rectly position the Loudspeaker as you desire.
5.
If you want to store the speaker settings in that zone to a
preset button, Press and hold the Store button on the remote
until all LED’s on the remote flash. Then press the On/Off but-
ton or one of the Preset buttons (1, 2 or 3) on the remote. The
LED’s on the remote should stop flashing.
NOTE:
if you want
to exit the store function without saving a preset, then simply
press the Store button on the remote a second time. When
you are done controlling that Loudspeaker press the Control
button on the remote.
6.
Go to the next Loudspeaker you wish to position by repeat-
ing steps 3 thru 5 above.
7.
Steps 3-6 can be repeated for different pre-sets for this
zone.
8.
Steps 1 thru 7 can be repeated for each loudspeaker zone,
as the system requires.
Note:
Loudspeaker movement and locations can also be
done through the use of the Time Tester application as de-
scribed in the Appendix.
TRIGGER INPUTS
If you want to use trigger inputs (3-30V A/C or D/C) to cause
the loudspeakers to come into the room in a specific loca-
tion, then set the Time Controller Auto Sense switch to the
OFF position. Then apply a trigger input from an external de-
vice to activate that mode.
For instance you could have a home theater zone have a
home theater setup and when the TV and the amplifier is
turned on, the trigger voltage sets the speakers to the home
theater position.
If the Amplifier is the only device to come on, then the speak-
ers go to the 5 speaker stereo position. To accomplish this you
may need to use external devices. However, some compo-
nents have voltage outputs that are designed for this use.
In addition there are devices that can be used as part of an
automated system that will provide voltage to enable the
modes. The voltage source must be connected to the trig-
ger-input jack on the back of the time Controller using the
wiring on the trigger input connector shown in Appendix A.
If you need help configuring this correctly, please contact
SpeakerCraft’s Technical Support or a SpeakerCraft Autho-
rized Installer.
TIME Series Controller
Page 4