USER’S MANUAL
EN
16
3
Start – Stop
4
5(-)
Arc Voltage
6(
+
)
12
Transfer
14
1
3
7
4
8
11
14
12
3
1
7
4
8
11
14
12
7.8 CNC CONNECTOR
ProCUT 45PFC plasma cutter is designed to work as a plasma source in cooperation with CNC
tables. Communication between CNC table and plasma cutter is performed by using a special
CNC control socket.
Diagram how to connect CNC control socket.
7.9 THE PROCESS OF CUTTING
SPARTUS® ProCUT 45PFC is equipped in standard with system of contactless arc ignition with
HF – high-frequency generator. There is no need for the nozzle tip to contact the surface to
ignite the plasma arc.
For manual plasma cutting, use a special spacers, included to the plasma torch. It is important
to puncture properly through the material and guide the plasma burner at a right speed to
maintain the proper penetration through material.
You should replace nozzles or electrodes for a new one in the following cases:
• when the nozzle head
(the hole in the nozzle)
is deformed, discalibrated,
• when electrod has cavities above 1mm,
• during the cutting plasma arc appear green flames,
• cutting gap is inclined or too wide,
• the arc flame is diffuse
(is not condensed)
.
7.10 THE TABLE BELOW FOR THE SHIFT AND SCALE SELECTION
The factory presets the voltage divider to 20:1. To change the voltage divider to a different setting:
1. Turn OFF the power supply and disconnect the power cord.
2. Remove the power supply cover.
3. Locate the voltage divider DIP switches on the left side of the power supply.
