EN
OPERATION OF THE BATHTUB
CLEANING
DRAINING
Installation of side panels
• Adjust the screws of the bottom stands to ba-
lance the bathtub body.
Connect a drain pipe (not supplied) to the drain
hole of the bathtub then connect the pipe to a
drain hole in the ground. You may use some
glue, if necessary. Follow the below drawing for
operation.
• Disconnect the bathtub before cleaning.
• Clean with soft cloth and light detergent.
• Note : Do not use rough tool or sanded detergent with chemical dissolvent to clean the bathtub.
• If there is a scratch on the bathtub, polish lightly with a sandpaper, apply toothpaste and then clean with soft cloth.
• The lime scale or dirt on the surface can be cleaned with light acid detergent (such as lemon juice) or heated wax. Wipe with soft cloth in the end.
• Do not wipe the chromed parts too often.
• Don’t strike or scratch the surface.
Metro a bolla
Tubo di scarico
Scarico
•
Don’t press the button A (3) to start the bubble massage until the water in
the bathtub is higher than the backflow hole.
•
Press the button C (4) to start or stop the water jet.
•
Turn the knob B (5) to adjust the strength of the water jet (clockwise for more
strength, anti-clockwise for less strength).
•
Press the button D (2) to control the lamps.
Don’t use too hot water. Fill the bathtub with cold water before hot water.
• Handle with care during installation so as to avoid scratches.
• Connect the draining switch with the draining pipe, and a soft pipe may be used in case
of a deviation between the drainage pipe and the ground hole.
• Take down the screws, ornamental cover and plastic gaskets, then take out the side
panel.
• Adjust screws of the foot stand to place the bathtub horizontally.
• Fix the panel as shown in the diagram. Insert the side panel between the bathtub edge
track and the fixed plastic board, then fix it with screws.
Screw
4
5
3
2
10
