Installations
(refer to Page 4 for parts)
:
Measure the distance between stove top and the bottom of
range hood. A distance of 30” to 36” is recommended*.
*
Due to different ceiling height configurations, recommend-
ed height may not be applicable.
Installation of Metal Liner Inserts
1. If the optional trim kit is used it must be installed prior to mounting the Metal Hood Liner into the wood
decorative hood. Use the provided #8 Phillips head screws. See Figure 3.
2. Lift the Metal Hood Liner into the decorative hood structure. Due to the weight of the assembly three people
may be required for proper installation.
3.
Install #6 x 1/2” screws through the pre-drilled EZ mount holes into the decorative hood structure. Tap
chrome cap into EZ mount holes for flush appearance See Figure 4.
4. Additional mounting fasteners may be used to secure to the back wall and top (from inside).
CAUTION: Make certain the range hood is secure before releasing!
5.
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure from the inside of hood.
6.
Use 8” round steel pipe (follow building codes in your area) to connect the exhaust on the hood to the duct
-
work above. Use silver tape or duct tape to make all joints secure and air tight. Refer to Figure 5.
SAFETY WARNING: Risk of electrical shock. this range hood must be properly grounded. Make sure this
is done by qualified electrician in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to prevent power from being
switched on accidentally.
7.
Connect the range hood to a designated standard outlet or cut off the plug and connect three wires (black,
white and green) to house wires and cap with wire connectors. Connect according to colors (i.e. black to
black, white to white, and green to green) as shown in Figure 6.
8. Store excess wires in the wiring box.
9.
Drop oil tunnel into recess support near rear of hood. Refer to Figure 7.
Page 11
Installation
Figure 4
Wood Hood
Mounting Holes
Figure 3
Screew
Trim Kit
Installation
(Continued)
Figure 7
Figure 6
Figure 5
Figure 8
10. To install baffle filters and stainless spacer(s), refer to
Baffle Filters and Stainless Steel Spacers
on Page 23 for baffle
filter and stainless spacer placement. Refer to Figure 8 for the following five steps:
Angle baffle filter toward back of hood.
Push baffle filter up until almost level.
Slide forward into recess behind the front of hood.
Lower baffle filter.
Slide back until it fits into resting positions.
11. Repeat Step 8 to install all baffle filters and stainless spacers.
12. OPTIONAL: Install heating lamps (not included) last. 220V or 120V (for USA & Canada), 250-Watt
maximum per lamp.
13. Turn powe ON in control panel. Check all lights and fan operations.
14. Make sure to leave this Installation Guide for the homeowner.
Page 10
