Add product to machine
1.
Verify machine has been recently sanitized (within
1 hour); if machine has not been recently
sanitized, verify door hand
-
screws are tight, and
perform sanitizing steps (Page 11).
2.
Thoroughly mix and prepare at least 8 liters (2.11
gallons) of product according to manufacturer
instructions; mix should be cool and smooth (free
of large chunks).
3.
Place bucket or large container below draw valve.
4.
Pour 2 liters (0.53 gallons) of product into hopper.
5.
For machine with air pumps, use filter when add
mix.
Do not
fill product over small air inlet holes on
the bottom of the air pump.
6.
OPEN draw valve (Handle Down); sanitizer will
start to flow out draw valve.
7.
Once sanitizer has been purged from the machine
and a steady stream of product is flowing from the
spout, CLOSE draw valve (Handle Up).
8.
Pour remaining product into hopper.
9.
Raise the prime plug on the top of the dispensing
door until flow is 100% product.
10.
Push prime plug back down.
11.
Wash air tube; install air tube in hopper (inlet hole
on side of air tube at bottom).
12.
For machine with air pumps:
→
Insert air tube into hopper but do not connect to
air pump
→
Press RESET, then press WASH to Prime
→
Ensure product is coming out of the large hole
near the top of the air pump. Press RESET
→
Rotate and insert air pump connector into air
pump; rotate connector to lock in place
13. Install hopper cover. Product is now ready to
freeze.
1
6
2
7
8
3
4
NOTE:
The mix
-
low lights illuminate
RED
when a hopper is low on product mix and automatically
de
-
illuminate when machine is filled.
NOTE:
Instructions assume product is added one hopper at a time. Repeat steps as needed.
9
10
12
13
5
12
12
11
Freeze product
1.
Verify cylinder is full of mixed product and primed.
2.
Press FREEZE button.
3.
The motor will begin to agitate the product, and the cooling system will begin to freeze the product.
4.
Freezing product takes approximately 10 minutes.
5.
When product reaches the set viscosity, it is ready to dispense (viscosity can be changed in the Settings
menu (Page 16).
13
Operating Control :
Freeze
Never
disconnect air pump (if present) with the machine running. If disconnecting air pump,
first
press
RESET to stop operations and open draw handles for 10 to 15 seconds to relieve pressure in cylinder.
