Spacelabs Healthcare 98000, Operation Manual

Page: 12 / 122

Pathfinder SL v1.9 Operations Manual
1-2
1.2.1 General
The software has been designed to be installed on a hardware system that complies with the
international safety standard EN 60950/IEC 950, which is designated as class 1 and stationary
equipment.
This equipment must be earthed (grounded).
This equipment is designed for internal use only.
The equipment should be installed near to a socket outlet that is readily accessible. Do not use
multiple portable sockets.
Do not attempt to remove any enclosures. There are no user serviceable parts inside.
Use only the connecting cables supplied.
Do not operate the equipment if any of the cables are damaged.
Switch off and unplug the equipment if it is not going to be used for a few days.
1.2.2 Precautions for Use
The equipment should only be used with the external enclosures fitted.
Do not expose the equipment to sudden extremes in temperature, direct sunlight or other heat
sources.
Do not spill any liquids onto the equipment. If you do, turn the equipment off and contact the
Service Department.
Do not drop the equipment or subject it to excessive bumping or jarring.
Do not obstruct, cover or poke objects into the equipment.
1.2.3 FCC Compliance and Advisory Notice
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. However, there is no guarantee that
immunity to interference to radio or television reception, which can often be determined by
turning the equipment off and on. If radio or television interference is suspected, the user is
encouraged to try and correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/television technician for help.