SPACECAM
SYSTEMS, INC.
MAXIMUS 7 OPERATOR’S MANUAL
August 17, 2016
PosLimTaper.
Set individually for each axis.
This parameter resides on the gimbal controller therefore can not be displayed or adjusted if the
communication to the gimbal is broken.
The taper is the axis’s maximum speed’s roll down angle in degrees for the position limits. To
avoid hard stops and malfunction of the position limit the velocity is proportionally lowered within
this range from the stop position. The minimum taper value is 2, the maximum is 50 degrees. The
actual command speed is always under the red speed limit. If the taper value is too low and the
camera operator slams the axis into the position limit too fast the inertia may drive the axis through
the limit and the function fails.
The last selected device will be the operating device for that axis after leaving the menu. That can be
changed easily on the main screen.
Exit from the setup menu by pressing MENU or BACK.
) control device from main screen:
In the main screen go to desired axis’ control device with the arrow keys.
Set desired operating device.
31240 La Baya Dr. Ste. A
Westlake Village, CA. 91362
818-889-6060
Page 19 of 74
