Form 43343530
Aug 2012
-23-
11.2)
ADDING 180º U-BEND (PTU ONLY)
1.
Hang body sections parallel with each other. The centerline distance from tube at each body section should
be 18” as shown.
2.
Join tube ends of body sections and the U-Bend together and secure with tube couplings as described in
Section 10.1).
18
(457mm)
Tube Coupling
U-Bend
Self-Drilling Screws
(QTY-2 per coupling)
11.3)
ADDING OPTIONAL U-BEND REFLECTOR (PTU ONLY)
1.
Place the U
U
U
U----Bend Reflector
Bend Reflector
Bend Reflector
Bend Reflector over the reflectors of each body section with the end resting next to the tube wire
hangers as shown.
2.
Slide the speed clips on the reflector edges towards the end of the body section reflectors. Two speed clips
are required for each side of the U
U
U
U----Bend Reflector
Bend Reflector
Bend Reflector
Bend Reflector. Make sure that the speed clips fit tightly over both the U
U
U
U----
Bend Reflector
Bend Reflector
Bend Reflector
Bend Reflector and the reflector on each body section. Use two self-drilling screws to permanently secure
both sides to the reflectors.
3.
Place the End Reflector
End Reflector
End Reflector
End Reflector flush with the U
U
U
U----Bend Reflector
Bend Reflector
Bend Reflector
Bend Reflector as shown. Note:
Note:
Note:
Note: Clearance between end of tttthe U
he U
he U
he U----
Bend Reflector
Bend Reflector
Bend Reflector
Bend Reflector and the U
U
U
U----Bend
Bend
Bend
Bend must be a minimum of 1
1
1
1”. Secure by sliding speed clips onto the end
reflector edges. Evenly space the speed clips on the sides (two each side) and top (three each) of the
reflectors to provide a snug fit.
Speed Clip
Part No. 02266010
(QTY-7)
U-Bend Reflector
Part No. 43490000
Wire Hangers
Speed Clip
Part No. 02266010
(QTY-4)
End Reflector
Part No. 43490050
#10 Self-Drill Screws
Part No. 02189020
(QTY-4)
1 Clearance
(between end reflector
and u-bend)