13
BEFORE USE
Attaching High Pressure Hose to Spray Gun
•
Pull slip ring on female quick-disconnect fitting of high
pressure hose back.
•
Insert male quick-disconnect fitting on spray gun into female
fitting on high pressure hose.
•
Release slip ring on female quick-disconnect and twist.
Listen for “click” to ensure both quick-disconnects are
coupled.
•
Pull high pressure hose and spray gun in opposite directions
to ensure they do not separate.
Connecting Lance to Spray Gun
•
Thread lance on to spray gun.
Connect Hose and Water Supply to Pump
•
Attach high pressure hose to the high pressure outlet on pump
as per attaching High pressure hose to spray gun. Be sure to
pull on hose to be sure of tight connection.
•
Before connecting garden hose to water inlet, inspect the inlet
screen. Clean screen if it contains debris or have it replaced
if damaged. DO NOT run pressure washer if inlet screen is
damaged.
•
Run water through your garden hose for 30 seconds to clean
out debris before connecting.
IMPORTANT:
DO NOT siphon standing water for the water supply.
Water supply must be at 20psi, failure to do so will cause the
pump to run dry and damage will occur voiding warranty.
Use cold water only (less then 50 Degrees Celsius).
•
Connect the garden hose (not to exceed 16 meters in length
and with the ID no less then 13mm) to the water inlet. Tighten
by hand.
•
Turn ON the water, squeeze the trigger to purge the pump
system of air and impurities.
NOTICE
DO NOT attempt to crank or start engine, before it has been
properly serviced and had the recommended oil added.
-
There MUST be at least 3meters of unrestricted garden
hose between the pressure washer inlet and any device,
such as a vacuum breaker or check valve.
-
Damage to equipment resulting from failure to follow this
instruction will void warranty.