SP Scientific FTS Systems BioCool 80, Manual, Page: 10 / 36

Introduction FTS Systems BioCool™ 80
2 Rev 002, 08/12
© SP Scientific 2012
Maximum Cooling Rates
The following cooling rates are achieved with ambient conditions of 22 ºC (72 ºF)
using clean methanol as the bath fluid. Some deviation from these rates may occur if
the ambient temperature is significantly higher or lower than 22 ºC (72 ºF), if the
methanol bath fluid is contaminated by water or if a different bath fluid is used.
Temperature Range Cooling Rate
20 to -60 ºC 2.5 ºC/minute
-60 to -80 ºC 1.3 ºC/minute
BioCool™ 80 Overview
The FTS BioCool™ 80 is designed for general freezing applications. This unit includes
a cascade refrigeration system and an on/off breaker switch. The BioCool™ also
features the Solo microprocessor controller, which provides precise temperature
control within ± 0.1 °C across the temperature control range of -80 °C to 20 °C.
1
When powered on, the BioCool™ 80’s refrigeration system will activate. After
approximately two (2) minutes, the green Chill light illuminates to indicate that the
second stage compressor is active.
The FTS BioCool™ 80 is also equipped with a solid-state variable speed-controlled
magnetic stirrer to provide more accurate temperature control and uniformity.
1
The FTS Systems BioCool™ 80 offers continuous operation at temperatures as low as -80 °C. Lowest possible temperatures
may be dependent upon the selected bath fluid, as well as ambient conditions and airflow.
Breaker Switch
Chill Indicator LED
Hinged, Stainless
Steel Insulated
Reservoir Lid
Fluid Stir Control Dial
Solo Microprocessor Controller