Description of the stud chuck
Operating Instructions Soyer Bolzenschweißtechnik
41
11.3 Installing the stud chuck (gun with support)
The installation of the stud chuck is shown using the example of the PS-3K Stativ
gun. The installation of the stud chuck into other guns with support is carried out
in the same way.
Step 9:
Insert a stud and check
the stud protrusion.
The stud / stud flange
must protrude 1.5 - 3 mm
from the support tube.
If applicable, correct the
setting of the stud chuck
(see chapter “ Adjusting
the stud chuck” on
page 38).
The assembly is complete.
Installing the stud chuck (gun without support).
1.5 - 3 mm
Installing the stud chuck (gun with support).
Step 1:
WARNING
WARNING
!
Switch off the stud welding device when the gun is con-
nected to it.
Step 2:
Set the stud chuck to the required stud.
Step 3:
Undo the clamping screws of the
support.
Step 4:
Undo the union nut (a).
If there is still a stud chuck (b) in
the gun, remove it.
a
b