50
maintain it well not to influence the truck operating safely.
The transporting channel of the truck should have well visual field, and it is easy to turn, and
no grade, steep slope, narrows channel and low roof board. The outline or the borderline must
be clear.
In the road where it is easy to meet the stepping truck, the width of the channel should be
adjusted.
Advising the grade of the channel should not over 10%, the top and the bottom of the slope
should transit smoothly, to prevent the load vibration or the bottom of the truck colliding the
ground.
When the grade is over 10%, installing a sign is advised.
If the truck is in operation (transport) and the load block off the sight, when the vehicle is
operating, the load should located on the backward of the truck operation direction.
For example: in some conditions (for example stacking and climbing), when the vehicle is
operating, the load is required on the forward of the vehicle operation direction. Then, the
driver should drive the vehicle carefully. It is necessary to attend: if the operation condition
require, should equip accessory (assistant) equipment or assistant.
The passage, road, runway, floor or slope should maintain good operating conditions, to
prevent the truck or the load from being damaged, and to prevent reducing the stability of the
vehicle.
In dangerous state, including the barrier danger on the top should mark on the clear location.
The fire fighting passage, the upstairs passage and the fire fighting equipment should
maintain expedite.
14.1.5.2 Gangplank or transition board
All the gangplank or transition board should has enough safety coefficients to bear the truck
with load. On the gangplank or transition board should marked the max passing load
perpetually.
The gangplank or transition board should fix firmly, to prevent the accidental move, vibration
or slide.
On the gangplank or transition board should equipped handing or other available equipment to
the effect of safety transport. On the conditions of possible, should set the fork hole or
suspending ear for moving goods.
The gangplank or transition board should have non-slip finishing.
On the both sides of the gangplank or transition board, should mount the facility to prevent the
truck from going over its edge.
When the gangplank or transition board is fixed its location, should adopt measures to prevent
the reverse joint truck from moving suddenly.
14.1.5.3 Lighting
When the photometric brightness on the operating field is less than 32LX, the vehicle should
equipped auxiliary light.
14.1.5.4 The suspending of the truck
The sling should be tied to the lifting spot which the factory appointed.
14.1.5.5 The synchronizing operation of the truck
Conveying bulky or heavy load using two trucks simultaneously is a dangerous operating which
requires special care. And this kind of conditions should be taken as special conditions and
carried out under the supervision of the operator responsible for operation.
14.1.5.6 Elevator (lifter)
The elevator (lifter) for transporting the industrial truck can bear the overall weight of truck,
load and the drivers. This kind of elevator (lifter) must be appointed, and the drivers should
use the appointed elevator (lifter).
14.1.5.7 Operating on the road vehicle (trailer) and rail vehicle
Before the motor industrial vehicle drive to the road, the road vehicle should apply the brake
and wedging to prevent moving.
Exception: the road vehicle equipped with automatic snap lock type parking brake can not use
the wedge.
The industrial motor truck passing in and out without connect to the tractor, to prevent the
semi-trailer hold up can use support.
It is necessary to build up the operating communication and operating order, to prevent the rail
vehicle move accidentally when downloading.
