For Machines Mfg. Since 5/11
14" TURN-X
®
Toolroom Lathe
-67-
M A I N T E N A N C E
Quick-Change Gearbox
Oil Type ...... Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ..................................................1Quart
Check/Add Frequency ....................................Daily
Change Frequency ...................................Annually
Checking Oil Level
The gearbox reservoir has the proper amount
of oil when the oil level in the sight glass is
approximately halfway. The oil sight glass is
located on the right side of the gearbox, as shown
in Figure 102.
Figure 102. Location of quick-change gearbox oil sight
glass.
Gearbox Oil
Sight Glass
Adding Oil
Use a
5
⁄
8
" wrench to remove the gearbox fill plug
(see Figure 103), then add the oil until the level
is approximately halfway in the gearbox oil sight
glass.
Figure 103. Locations of the quick-change gearbox fill
and drain plugs.
Fill
Plug
Drain
Plug
Draining Oil
Place a catch pan under the quick-change
gearbox drain plug (see Figure 103), use a
5
⁄
8
"
wrench to loosen the fill plug and remove the
drain plug, then allow the gearbox reservoir to
empty.
Apron
Oil Type ...... Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ............................................ 1.2 Quarts
Check/Add Frequency ....................................Daily
Change Frequency ...................................Annually
Checking Oil Level
The apron oil sight glass is on the front of the
apron, as shown in Figure 104. Maintain the
oil volume so that the level is approximately
halfway in the sight glass.
Figure 104. Location of apron oil sight glass.
Sight
Glass
Draining Oil & Flushing Reservoir
Since the apron oil reservoir supplies the one-
shot oiler, the oil is constantly being refreshed
when the reservoir is filled. However, small
metal particles may accumulate at the bottom of
the reservoir with normal use. Therefore, to keep
the reservoir clean, drain and flush it at least
once a year.
Summary of Contents for SB1039F insert
Page 136: ...Printed In U S A TS14364 ...
