OPERATING AND CLEANING INSTRUCTIONS
SECTION 4: SELF-GENERATING COUNTER TOP
STEAM JACKETED KETTLES
OPERATING PROCEDURE
a) Check that external Control Box Switch is ON.
b) Check kettle Pressure Gauge that reading indicates 20 - 25 vacuum for a
cold kettle. If vacuum is insufficient. Air Venting Instructions must be
followed.
c) Place Kettle Power Switch in ON position.
d) Preheat kettle by turning Thermostat Knob to '8' and wait until
Temperature pilot light goes off.
NOTE: Food products with milk or egg base should be placed into cold
kettle and then the cooking operation begun. Avoid sudden
contact of these food products to hot kettle bowl surface since
caking and adhering will occur.
e) Place food product into kettle bowl.
f) Adjust Thermostat Knob to temperature cooking mode. Setting of
4 - 6 will provide simmer and 7-10 low to rolling boil.
g) Turn both kettle Power Switch and Thermostat Knob OFF when cooking has
been completed.
h) Remove food product by ladling out of kettle bowl or by tilting
and pouring into a suitable container.
i) Clean immediately to prevent residue from drying and adhering to
kettle bowl surface.
CLEANING PROCEDURE
a) Turn power supply OFF to kettle.
b) Using a nylon brush, scrub kettle bowl with a warm water mild
detergent wash solution. Never use steel wool or abrasive scouring pads
as they will scratch and ruin the general appearance of the kettle and
make it more difficult subsequently to maintain in a clean sanitary
condition.
c) Tilt kettle and pour out wash solution.
d) Rinse kettle bowl with clean water and dry.
e) Food adhering excessively to bowl surface may be loosened by
allowing water to soak in bowl at a low temperature setting.
f) Wipe down exterior of kettle and console housing with clean damp cloth.
NEVER SPRAY WATER INTO ELECTRIC CONTROLS
Summary of Contents for KECT-05F
