South-Tek Systems Quick-Check 1, Manual, Page: 27 / 30

Quick-Check-PowerSaver Manifold 6 Port South-Tek Systems
Revision: 0
Revision Date: 8/2/17
Page 27 of 30
Figure 27: APS 4 Settings
5. Once the float bead has stabilized, the ¼” tubing may be re-connected to the appropriate zone port on the
Quick-Check PowerSaver Manifold.
10 FAQS
This section enables the operator to determine the cause of operation problems and suggests remedies for the
problems. If there are several likely causes, investigate the simpler solutions first. If further assistance is required,
contact your local distributor or South-Tek Systems.
Symptoms Probable Cause Corrective Action
System Not
Powering On
Too Low or Too High
Voltage/Amperage
Check Electrical Source
Circuit breaker tripped Reset circuit breaker
Fuse Blown Replace fuse on electrical panel
System is OFF (Selector switch on
Home screen is in the OFF position)
Touch the switch to turn it to the ON position
Defective Wiring Check all wired connections
Purity Status
Remains
Too little or no flow to Quick-Check Check APS flow settings and ball valve position
Leak within system Check for leaks
Figure 25: APS 2 Settings
Figure 26: Alphabetical
Indicators