-36-
For Machines Mfg. Since 7/09
EVS Toolroom Lathes
O P E R A T I O N
Faceplate
Refer to
Chuck & Faceplate Mounting
instructions on
Page 27
to mount the faceplate
to the spindle.
The 12" faceplate included with your lathe offers
a wide range of uses, including machining non-
concentric workpieces, straight turning between
centers, off-center turning, and boring.
The tools needed for mounting a workpiece will
vary depending on the type of setup you have.
Mounting Workpiece with Clamps
1.
DISCONNECT LATHE FROM POWER!
2.
Place a piece of
3
⁄
4
" plywood on the bedway
below the spindle.
3.
With help from another person, place the
workpiece onto the faceplate and clamp it in
place with a minimum of three independent
clamping devices (see
Figure 63
for an
example).
Note:
Be sure to take into account the rotation
and cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
4.
Double check tool and slide motion
clearances before turning spindle
ON
.
Mounting Workpiece Between
Centers
1.
DISCONNECT LATHE FROM POWER!
2.
Drill center holes in both ends of the
workpiece.
3.
Install the dead center in the spindle and the
live center or carbide-tipped dead center in
the tailstock (refer to
Page 37
).
4.
Secure a lathe dog on the spindle-end and
place a drop of oil in the center hole on the
tailstock-end of the workpiece.
5.
Mount the workpiece between centers so the
lathe dog tail fits freely in the faceplate slot
without binding.
Failure to properly secure a workpiece to the
faceplate could cause the workpiece to be
thrown from the lathe with deadly force at the
operator or bystanders. Use a minimum of
three independent clamping devices to hold a
non-concentric workpiece onto the faceplate.
Machining non-concentric workpieces at a
high speed could cause the workpiece to be
thrown from the spindle with deadly force at
the operator or bystanders. To reduce this
risk, only machine non-concentric workpieces
at low speeds and clamp counter-weights to
the faceplate to balance it.
Figure 63. Example of workpiece clamped in a
faceplate.
Clamp
Non-Cylindrical
Workpiece
Faceplate
Figure 64. Example of using faceplate to mount work
between centers.
Dead Center
Lathe Dog
Faceplate
