-30-
For Machines Mfg. Since 7/09
EVS Toolroom Lathes
O P E R A T I O N
Figure 48. Correct camlock stud alignment.
Not Correct
Not Correct
Correct
3-Jaw Chuck
Refer to
Chuck & Faceplate Mounting
instructions on
Page 27
to mount the 3-jaw
chuck to the spindle.
The 3-jaw scroll-type chuck included with this
lathe features hardened steel jaws that center the
workpiece. When the operator opens or closes the
jaws with the chuck key, the jaws move in unison.
There are two sets of removable hardened steel
jaws included with the 3-jaw chuck—inside and
outside jaws. Use the correct jaws for the size
and configuration of the workpiece to hold it
firmly and securely on the chuck (see
Figure
49
). The outside of the jaws are used to hold the
workpiece from the outer diameter.
Figure 49. Chuck and jaw selection.
Numbered from 1–3, the jaws must be used in
the matching numbered jaw guides, as shown in
Figure 50
.
Figure 50 Jaw guides and jaw numbers.
Jaw Guide #1
Jaw
Numbers
Note:
The chuck does not need to be removed
from the spindle to swap the jaws.
