-44-
For Machines Mfd. Since 7/21
South Bend Tools
Model SB1123
O P E R A T I O N
Tilting Table
The table can be tilted from 5° left–45° right to
make beveled cuts. A table tilt scale with pointer
is provided on the trunnion, and a positive stop is
provided for quickly returning the table back to
0° from a right-tilt setting (see Figure
61).
Note:
The tilt scale on the trunnion serves as a
guide only. For more accurate results use a bevel
gauge or protractor to set the desired table tilt
relative to the blade.
1.
DISCONNECT
MACHINE FROM POWER!
2.
Loosen table tilt lock lever (see Figure
61).
3.
Rotate table tilt handwheel until table
reaches desired angle, then retighten lock
lever.
Tilting Table
Figure
Figure 61. Table tilt controls.
. Table tilt controls.
Trunnion
Trunnion
Table Tilt
Table Tilt
Scale
Scale
Table Tilt
Table Tilt
Lock Lever
Lock Lever
Pointer
Pointer
Table Tilt
Table Tilt
Handwheel
Handwheel
Installing Blade
4.
Rotate blade tension quick-release lever
counterclockwise to PARTIAL TENSION
position.
5.
Adjust blade tension (refer to Page 27) and
blade tracking (refer to Page 28).
6.
Adjust upper/lower guide bearings and
support bearings (refer to instructions
beginning on Page 30).
7.
Close and secure wheel covers, and re-install
table insert and table pin.
8.
If necessary, adjust blade tension quick-
release lever (refer to Page 59 for more
information).
Figure 60. Example of placing blade on upper wheel.
Figure 60. Example of placing blade on upper wheel.
!
Tools Needed
Qty
Hex Wrench 6mm .................................................1
Wrench or Socket 10mm .......................................1
1.
DISCONNECT MACHINE FROM POWER!
2.
Slide blade through table slot, ensuring teeth
are pointing down toward front of table.
Note:
If the teeth will not point downward
in any orientation, the blade is inside-out.
Remove the blade, and twist it right-side-out.
3.
Slip blade through blade guides, and
mount it on upper and lower wheels (see
Figure
60).