South Bend Tools
For Machines Mfd. Since 11/20
Model SB1099
-19-
P R E P A R A T I O N
27.
Attach rear panel to base with (3)
5
⁄
16
"-18
x
3
⁄
4
"
button head cap screws and
5
⁄
16
" flat
washers (see Figure 23).
28.
Attach housing assembly to rear panel with
(3)
5
⁄
16
"-18 x
3
⁄
4
" button head cap screws (see
Figure 24).
Figure
Figure 24. Flange bolts connecting housing assembly
. Flange bolts connecting housing assembly
to rear panel.
to rear panel.
x3
x3
Figure
Figure 23. Rear panel attached to base.
. Rear panel attached to base.
x3
x3
Rear
Rear
Panel
Panel
29.
Position filter cover assembly over housing
assembly. Rotate lower alignment arm so
upper alignment arm on underside of cover
assembly (see Figure 25) captures lower
arm when mounting holes align to housing.
Figure 25. Underneath filter cover assembly.
Underneath filter cover assembly.
Upper
Upper
Alignment
Alignment
Arm
Arm
30.
Attach filter cover assembly to housing
assembly with (6)
5
⁄
16
"-18 x
3
⁄
4
" flange bolts
(see Figure 26).
31.
Route filter brush motor cord into housing
through strain relief (see Figure 26), then
tighten strain reliefs on top and bottom of
housing.
Figure 26. Filter cover attached to housing assembly.
Filter cover attached to housing assembly.
Filter
Filter
Cover
Cover
x6
x6
Filter Brush
Filter Brush
Motor Cord
Motor Cord
32.
Attach end cap to bottom of canister filter
and attach end cap cover (see Figure 27).
Figure
Figure 27. End cap attached to canister filter.
. End cap attached to canister filter.
Canister
Canister
Filter
Filter
Cap Cover
Cap Cover
End Cap
End Cap
