4 PIN SHOCK SENSOR CONNECTOR
FULL TRIGGER INPUT
BLACK
GROUND OUTPUT FOR AUXILIARY SENSOR
BLUE
WHITE
PRE-WARN TRIGGER
RED
12VOLT OUTPUT FOR AUXILIARY SENSOR
1- WHITE Pre-Warn Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the system will chirp the SIREN 3 times.
2- BLUE Full Alarm Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the alarm will activate for up to 60 sec.
3- BLACK Sensor Ground Output (-)
This wire provides a ground output for the auxiliary sensor.
4- RED Sensor 12volt Output (+)
This wire provides a 12volt output for the auxiliary sensor.
1- ORANGE Wire- Ground When Running (-)
Connect this wire to the your bypass modules negative turn on wire. When the remote starter is activated this
wire will switch to ground.
2- BLACK Wire- System Ground (-)
Connect this wire to the ground input on the bypass module.
3- RED Wire- N/A
3 PIN BYPASS CONNECTOR
GROUND OUTPUT
N/A
BLACK
ORANGE
GROUND WHEN RUNNING OUTPUT
T
hese inputs are used to connect bypass modules and other devices such as GPS tracking using the data to
data type connection. For bypass modules there are 2 selection types. The default setting is set for FORTIN™
Bypass Module, the second is for IDATA™ Bypass Modules
.
4 PIN DATA BYPASS CONNECTORS
SYSTEM PROGRAMMING -
Menu 1
PAGE 14
INSTALL MANUAL
SYSTEM WIRING DETAILS
ARS.1
SYSTEM PROGRAMMING -
Menu 1
PAGE 15
INSTALL MANUAL
SHOCK SENSOR
If the system has been triggered (shock sensor, door input..), the siren will sound for
approximately 60 seconds. Press and release the lock or unlock button to silence the
siren (the system will remain armed). Press the unlock button to disarm the system. The
siren will chirp and the park lights will flash three times to indicate the system had been
triggered.
If the shock sensor is triggered 3 times in a row the system will ignore the shock sensor
until the ignition is turned cycled on then off.
ARS.1
SHOCK SENSOR ADJUSTMENT
The supplied dual stage shock sensor connect’s directly to the shock sensor connector on the
remote starter module. The adjustment screw on the sensor will increase or decrease the
sensitivity. The first and second stage are controlled by the same adjustment screw.
Test the alarm sensitivity then adust as required. If the alarm is triggered 3 times in a row you
will need to cycle the ignition on then off to reset the shock sensor before testing again.
NOTES
Adjustment Screw
Zone LEDs
Mounting Bracket
Use the mounting bracket’s to firmly attach the
shock sensor to the under dash area of the vehicle
before setting the sensitivity.
