8
ENGLISH
ZEPHIRO 1500 LOW fog User manual
f
The power cord must be connected to a grounded electric outlet. Once connected,
turn ON the machine with the corresponding switch and then the heating process
will start which will last about 4 minutes. After that the fog machine is ready to use.
f
Use the supplied remote control to control the machine.
6. MAINS CONNECTIONS
Connect the device to the mains with the supplied power cable. Please note that power
voltage and frequency are the same as the marked voltage and frequency of device
when connecting power.
Wire correspondence is as follow:
Cable (EU)
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth must to be connected! Pay attention to safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
7. DMX CONNECTION
DMX fixtures are designed to receive data through a serial Daisy Chain. A Daisy Chain
connection is where the DATA OUT of one fixture connects to the DATA IN of the next
fixture. The order in which the fixtures are connected is not important and has no effect
on how a controller communicates to each fixture. Use an order that provides for the
easiest and most direct cabling.
DMX Termonator
Unit 1
Unit 2
Last Unit
DMX 512
Connect fixtures using shielded 2-conductor twisted pair cable with 3-pin XLR male to
female connectors. The shield connection is pin 1, while pin 2 is Data Negative (S-), and
pin 3 is Data positive (S+).
