Test
Sound:x
UP/DOWN to choose Y off sound active model 1-9,
press ENTER to save
Test
Tilt:xxx
UP/DOWN to adjust Y value address, press ENTER
to save.(only active with
Auto:x and Sound:x
)
MENU5:
PassWord
|
Press
ENTER
PassWord
UnLock
Password---unloack. set up three-digit-number
password.
ENTER→UP/DOWN
to
choose
digit(0-
9)→ENTER. Default password is 988. Power
off fixture to active password unlock function
PassWord
Lock
Passwork-lock. Password---unloack. set up
three-digit-
number password. ENTER→UP/DOWN
to choose digit(0-
9)→ENTER. Default password is
988. Power off fixture to active password lock
function.
MENU6:
Re- Def-
ENTER TO RESET factory defaults
MENU7:
Reset
ENTER to RESET
Comment: Press MENU to back to the last option. Press ENTER to save.
How to erase password: Please press MENU→UP/ DOWN→MENU SYS-SET→ENTER→UP/
DOWN→SYS-SET
Password→ENTER→UP/
DOWN→NO→ENTER→password(default
988)→ENTER
DMX Protocol
(12CH
）
CH
Function
Description
CH1
Y
0-255
CH2
Y 16 bit
0-255
CH3
Dimmer
0-255 from dark to bright
CH4
R
0-255 from dark to bright
CH5
G
0-255 from dark to bright
CH6
B
0-255 from dark to bright
CH7
W
0-255 from dark to bright
Cable Connectors
Cables must have a male XLR connector on one end and a female XLR connector on the
other end.
A word on termination: DMX is a resilient communication protocol,
however errors still occasionally occur. Termination reduces signal errors, and therefore best
practices include use of a terninator in all circumstances. If you are experiencing problems
with erratic fixture behavior, especially over long signal cable runs, a terminator may help
improve performance.
To build your own DMX Terminator: Obtain a 120-ohm, 1/4-watt
resistor, and wire it between pins 2&3 of the last fixture. They are also readily available from
specialty retailers
.
Complimentary signal cable can transmits signals to 20 unit fixtures
at most. Signal amplifier is a must to connect more fixtures
