Section 3. Troubleshooting
Section 4. Reference
Control Menu
DMX Protocol
Specification
Control Menu
Operation
Display
Description
MENU1:
Dmx512
|
PRESS
ENTER
Dmx512
17CH: xxx
UP/DOWN to choose 1-512, press ENTER to save
Dmx512
12CH: xxx
UP/DOWN to choose 1-512, press ENTER to save
MENU2:
Tilt
|
PRESS
ENTER
Tilt
No
Y clockwise, press ENTER to save
Tilt
Yes
Y anti-clockwise, press ENTER to save
MENU3:
Manual
|
PRESS
ENTER
Manual
CH01
：
xxx
…
Manual
CH17:xxx
UP/DOWN to adjust value 0-255, press ENTER to
save.(CH01 to CH17respects for 17CH same fu
nction as DMX512 console
MENU4:
Test
|
Press
ENTER
Test
MAuto:x
UP/DOWN to choose Y RUN auto model 1-9, press
ENTER to save
Test
Auto:x
UP/DOWN to choose Y off auto model 1-9, press
ENTER to save
Test
MSound:x
UP/DOWN to choose Y RUN sound-active
1-9,press ENTER to save
Probable cause(s)
Remedy
No response from
fixture when power
is applies
No power to fixture
Check power cables
Primary fuse blown
Replace fuse
Secondary
fuse
blown
Replace fuse
Fixture resets but
does not respond
correctly
to
controller(DMX
mode operation)
Controller
not
connected
Connect controller
Incorrect
addressing of the
fixtures
Check address setting on fixture and controller
Bad
data
link
connection
Inspect cables and correct poor connections
and/or broken cables.
Conflict
between
tracking and vector
control
Eliminate scene cross-fade on controller
Data
link
not
terminated
Insert termination plug in output of last fixture
Defective fixture or
2
devices
transmitting on link
Bypass fixtures one at a time until normal
operation is regained:unplug both connectors and
connect them directly together
Colors cannot be
mixed
Random
color
mixing is on
Turn off random color mixing
Fixture does not
reset correctly
Electronic
or
mechanical failure
Contact service technician
No light, lamp cuts
out intermittently,or
burns out too
quickly
Lamp missing or
blown
Disconnect fixture and replace lamp
Fixture or lamp is
too hot
Allow fixture to cool. If problem persists,contact
service technician
