1.800.338.7337 / www.soundoffsignal.com
7
7X3 / 6X4 P SERIES_STT
00KPJL 0822 REV B
SCREW MOUNT INSTALLATION:
INSERT MOLY ANCHORS INTO DRILLED HOLES, FULLY
SEAT TO MOUNT SURFACE
ALIGN GASKET TO MOUNT SURFACE
(
NOTE HORIZONTAL AND VERTICAL ORIENTATIONS
INDICATED ON GASKET FOR PROPER SEAL)
PLACE BEZEL OVER GASKET
PULL THE WIRE HARNESS
THROUGH THE OPENING AND
PLUG INTO THE BACK OF THE
PLACE LIGHT INTO BEZEL, PRESSING BEZEL,
AND GASKET AGAINST MOUNT SURFACE
SUPPLIED SCREWS.
(
TIGHTEN UNTIL GASKET IS COMPRESSED, DO NOT OVER
TIGHTEN AND STRIP MOLY ANCHORS.)
SCREW HOLES.
COATING THE EXTERIOR OF THE PLUG IN 50%
ISOPROPYL ALCOHOL, 50% WATER MIX (HAND SANITIZER
WORKS WELL) WILL ALLOW THE PLUG TO SLIP INTO PLACE
EASIER, AND THE MISTURE WILL EVAPORATE OUT LEAVING
NO RESIDUE.
DRILL FOR WIRE EXIT
DRILL FOR SCREW MOUNT
5
C
L
CL
SURFACE MOUNT
FIG. 9
DRILL FOR WIRE EXIT
DRILL FOR SCREW MOUNT
C L
CL 5
SURFACE MOUNT
FIG. 10
NOT TO SCALE, FOR REFERENCE ONLY
7X3 SCREW MOUNT TEMPLATE
6X4 SCREW MOUNT TEMPLATE
NOT TO SCALE, FOR REFERENCE ONLY
FIG. 8
6X4 SCREW MOUNT LIGHT PICTURED
GASKET
WIRE
HARNESS
BEZEL
WELL NUTS
SCREWS
FLAT WASHERS
1. Drill (4) 5/16" holes to mount light. Drill 3/4" wire hole. See Fig.
9 (7x3) OR Fig. 10 (6x4).
2. If a bezel is being used, place bezel over light.
3. Place the gasket on the back of the light and bezel (if used).
NOTE: Horizontal and vertical orientations indicated on gasket
for proper seal.
4. Insert the (4) supplied screws into each screw hole.
5. Place (4) flat washers over the screws on the back of the light.
6. Screw onto each fastener the (4) well nuts onto the back of the
light. Tighten until snug.
7. Pull the wire harness through the opening and plug into the
back of the light. Reference page 8 for retention clip installation.
8. With the light assembly in hand, insert the well nuts into the 4
drilled holes. Fully seat to mounting surface.
9. Secure the light to mounting surface. While applying pressure
on each fastener, tighten the (4) screws 7 full turns.
NOTE: Tighten until gasket is compressed. DO NOT over
tighten.
