SCD5950 / English Instruction Manual
2
POWER SOURCE
AC connection
Before operation please ensure voltage on the set corresponds to voltage of your local area.
Unravel AC cord set; insert one end into an AC socket on the unit while the other end into a
standard AC outlet.
Remarks
:
1) In case of malfunction due to electrostatic discharge (ESD), reset the unit by reconnecting
AC cord again to resume to normal operation.
2) When not in use
– Unplug AC power cord completely from AC power socket. The Mains
plug of AC power cord is used as disconnecting device; the disconnect device shall remain
readily operable.
BATTERY INSTALLATION
Disconnect AC Cord set completely. Open the BATTERY DOOR and insert UM-
1/ “D” size x 4
batteries (not supplied) making sure the indicated battery polarity is observed.
When not in use
– Remove all batteries if the unit will not be used for several months or more.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old
batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
5. Do not try to recharge batteries, which not intended to be recharged; they can overheat and
rupture. (Please follow battery
manufacturer’s directions.)
6. Battery shall not be exposed to excessive heat such as direct sunlight, fire or the like.
ENERGY SAVING/ ERP2 REGULATION
This device is equipped with an automatic switch off / STANDBY system for energy-saving
requirements. This is regulated by an EU-standard and is NOT A MALFUNCTION.
CAUTION
There is danger of explosion if battery is incorrectly replaced. Replace
the battery only with the same or equivalent type.
