SoundCraft MBI 10 Series, User Manual

Page: 27 / 54

Meterbridge
Wiring
The meterbridge is equipped with a distribution board, SC3357, to which the
meterbridge modules are connected. The optional meterbridge equipment (listed
below) can be user-connected to this distribution board via the wiring harness which
is supplied with the optional equipment.
Options
The 24 module-width frame has space for 24 meterbridge-option widths and the 32
module-width frame has space for 32 meterbridge-option widths. Note that a
meterbridge-option width is not the same size as an input-module width: the
meterbridge-option width is slightly smaller in order to accommodate the edges of
the meterbridge frame.
The following options are available:
LED Master Meters (Std) . . . S10LED . 4MW (Meterbridge-Option Width)
Large VU Master Meters . . . S10VLR . 8MW
Single Large VU Meter . . . . S10V1 . 4MW
Small VU Meters . . . . . . . S10V2 . 4MW
Large PPM Master Meters . . S10PLR . 8MW
Single Large PPM Meter . . . S10P1 . 4MW
Small PPM Meters . . . . . . S10P2 . 4MW
RTW Panel (inc. loom
but excluding Meter) . . . . S10RTW . 8MW
PFL/TB Loudspeaker Module S10MBS . 4MW
Talkback Remote Module . . . S10TB . 4MW
Double Meterbridge Blank . . S10MB8 . 8MW
Single Meterbridge Blank . . . S10MB4 . 4MW
Timer . . . . . . . . . . . . S10TIM . 4MW
Input Selector . . . . . . . . . S10SEL . 4MW
Meterbridge Distribution Board
The diagram for this PCB is shown overleaf. Fitting instructions are provided
with the optional Meterbridge Modules.
Installing Meterbridge Modules
1) Raise the Meterbridge housing and secure in the raised position with the two
wingnuts.
2) Unscrew the blanking plate in the required location.
3) Mount and secure the module in the meterbridge.
4) Connect the module’s loom to the relevant connector.
5) Loosen the wingnuts and carefully lower the meterbridge.
Applications 21