www.soundskulptor.com
Document revision 1.1 – Last modification : 21/04/08
PSL1 Assembly guide
10. Connectors
Add CN3, CN4.
After soldering, cut the pins flush. The pins are not very long but they carry mains voltage and the
clearance distance between them and the case must be respected.
Warning
: Make sure to position the connector in the right direction which is identified by the latching pin
on the PCB.
11. 115/230V Selector switch
Add SW2.
12. Fuse holder
Add the fuse holder.
13. Bridge rectifiers
Add BR1, BR2, BR3.
Warning
: Make sure to respect the direction of the bridge rectifiers, It is marked by + and - signs.
14. Medium size electrolytics
Add C9, C10, C11.
15. XLR Socket
Add CN1. The position of the socket is critical for a good backplate matching. It must sit flat on the
PCB. Press firmly the socket on the PCB and solder one of the centre pins. Check position then solder
the other pins.
16. Large Electrolytics
Add C2, C6
Copyright ©2008 SoundSkulptor
