www.soundskulptor.com
Document revision 1.1 – Last modification : 21/04/08
PSL1 Assembly guide
22. Single heatsink assembly
Place a drop of thermal compound on the heatsink front face, the volume of a grain of
rice. The back face can be identified by the countersunk hole.
Next place the mica insulator.
Place a second drop of thermal compound on the mica insulator.
Insert the M3x10 countersunk screw from the back, the LM317 regulator and the
Insulating shoulder washer.
Place the M3 nut and tighten all together.
Use your digital multimeter in the Ohm position to check that there is no connection
between the heatsink and the center pin of the regulator.
23. Dual heatsink assembly
Repeat the same operations for the two regulators of the dual heatsink.
LM317 on the left,
TL783 on the right.
24. Case assembly
Assemble the front plate and the two sides of the case with four
black M4 countersunk srews.
The internal face of the sides is the one with a single groove.
25. Transformer plate assembly
Place two M3x6 pan head screws with two nuts on the transformer plate
and slide it into the right side of the case.
Copyright ©2008 SoundSkulptor
M3x10 screw
Heatsink
Thermal compound
Mica
insulator
Regulator
Shoulder
washer
Nut
