following message
and after 2 sec. The Eth led will be turned off and the system will return to this menu
If communication is successful, then on the display will display the current Volume State
...
...
through Encoder is possible to change the Volume value (range between-127.0 dB to + 18dB) and
in real-time the parameter will be updated on DPA880T
using Encoder it is possible to choose the variation of the Volume in steps of 0.1 dB or 1dB
Press the Esc key to return to the start screen
3.
LOAD PROGRAM
After pressing the SET button, the Eth led will lit as the system sends a message to DPA880T to ask
which preset is loaded and read the names of the program.
If the preset currently uploaded on DPA880T is an extra presets (preset from 7 to 10, activated via
inputs S1,..,S4 available on the back panel) the display will then show the message
and after 2 sec. The Eth led turns off and returns to the previous screen
This is because the extra presets are associated with special events and these have priority on
preset 1 - 6, recallable from front-panel using the buttons 1 - 6.
If the CP8 is not connected to the DPA880T or the ID is not correct then the display will show the
Volume [dB]
Device not connected
Output 2
Volume
Volume [dB]
Step=0.1dB V=-
127.0
Volume [dB]
Step=0.1dB V=0.0
Volume [dB]
Step=0.1dB
V=+18.0
Output 2
Volume
CP8 CTRL PANEL
Load Program
Load Program
not possible
CP8 CTRL PANEL
Load Program
