© 2012-2021 SOTA Instruments Inc.
Page 7 of 14
|
www.sota.com
The Silver Pulser Model SP6 Manual
Options:
a. If preferred the unit can be placed in a pocket.
A longer Micropulsing Cord is needed for this
option.
b. If the Arm Band is too large a shorter Arm Band is
available.
3. Put the Wrist Strap on with the Velcro
®
side of the
Wrist Strap face-out rather than towards the skin.
4. Prepare one pair of Cotton Sleeves. Each Cotton Sleeve is
sewn on three sides; to find the open end of the Cotton
Sleeve, squeeze the long sides of the sleeve and the
unsewn end will pop open.
5. Attach one Cotton Sleeve to the Wrist Strap in line with
the pulse point on the thumb
side of the wrist. The open end
of the Cotton Sleeve will point
down toward the elbow. Press the
sleeve to the Wrist Strap to firmly
adhere the sleeve in place.
6. Place the other Cotton Sleeve, again with the open side
towards the elbow, in line with the pulse point on the little
finger side of the wrist. This pulse point is usually harder to
feel. It is located in the soft hollow on the wrist, in line with
the little finger. Press the sleeve to the Wrist Strap to firmly
adhere the sleeve in place. See image 6.
Once in place, the Velcro
®
will hold the Cotton Sleeves in the
right position for repeated use.
7. Take the Wrist Strap off.
8. Insert one probe from the Micropulsing Cord into the open end of each Cotton
Sleeve. Use a gentle twisting motion to work the Rubber Probes into the Cotton
Sleeves.
9. Wet the Cotton Sleeves with water.
10. Put the Wrist Strap on so the damp Cotton Sleeves are against the skin over the
4
6
5